Aktivität von Maximilian Seesslen
von 11.11.2023 bis 10.12.2023
10.12.2023
-
12:18 libcampo Feature #448 (Erledigt): hwdata: dump whole eeprom to bin files
-
12:18 Biwak Feature #451 (Erledigt): support direct gpio init
-
10:19 Biwak Feature #455 (Erledigt): change beckon behaviour
-
10:17 Biwak Fehler #456 (Erledigt): link-script: section '.marker' is not marked with '(NOLOAD)'
-
07:08 Hardware Wiki-Bearbeitung: IDs (#19)
09.12.2023
-
14:58 Hardware Wiki-Bearbeitung: IDs (#18)
07.12.2023
-
16:41 Hardware Wiki-Bearbeitung: Shops (#62)
-
16:41 Hardware Wiki-Bearbeitung: Shops (#61)
-
16:05 Hardware Wiki-Bearbeitung: Shops (#60)
06.12.2023
-
18:45 libcampo Feature #457 (Erledigt): Track library release sizes
- Unfortunately libraries are quite tied to matching versions of other libraries so those comparison is difficult to re...
05.12.2023
-
16:44 Biwak Feature #452 (Abgewiesen): curly brace init for periphery typedefs in peripherie constuctors
- This increased binary size daramtically.
-
16:34 Biwak Fehler #456 (Erledigt): link-script: section '.marker' is not marked with '(NOLOAD)'
- Test again if size is an problem then. 'rufa' is an good candidate. Should fail with missin '(NOLOAD)' and succeed wi...
-
16:04 Biwak Feature #455 (Erledigt): change beckon behaviour
- * reduce warn-blink-time to 5 minutes
* introduce beckon-blinking (warning-blinking is confusing)
* beckon not poss... -
14:12 Hardware Wiki-Bearbeitung: Design_rules (#31)
-
14:12 Hardware Wiki-Bearbeitung: Design_rules (#30)
-
11:51 Hardware Wiki-Bearbeitung: Design_rules (#29)
04.12.2023
-
11:21 Rufa Feature #454 (Neu): Verify smoothener
- Smoothing and error detection was implemented.
Once the LED-Lamp was switched off, the noise was completely gone.
...
30.11.2023
-
21:03 Biwak Feature #452 (Abgewiesen): curly brace init for periphery typedefs in peripherie constuctors
- Should be more clean.
-
20:40 Biwak Feature #451 (Erledigt): support direct gpio init
- arena can initialize gpios for periphery like CAN, SPI and I2C directly in the generated init-function.
The GPIOs ar... -
15:54 liblepto Feature #450 (Neu): CRing: the m_top/m_bottom concept wastes one entry
- Use an m_top/m_entries approach.
Would not be thread-save. Additional counter needed.
Round-Counter-Bit would help.... -
15:48 liblepto Fehler #447 (Erledigt): crc32: the finalize step is integrated into calcCrc32()
29.11.2023
-
14:09 Biwak Feature #449 (Abgewiesen): Test "_end_data_flash"
- Setting an symbol to the first usable area has some problems on 16k devices when there is no free sectors.
_start_us...
28.11.2023
-
18:08 libcampo Feature #448 (Erledigt): hwdata: dump whole eeprom to bin files
- the readout can be implemented in gdb script....
-
12:02 liblepto Fehler #447 (Erledigt): crc32: the finalize step is integrated into calcCrc32()
- Probably all crc32 calculations in the EEPROMs are wrong.
Unit tests are needed: update_crc32, finalize_crc32...
... -
10:39 liblepto Feature #446 (Erledigt): Catch CRC32 polynom for STM32F1
- The result is different than current CRC32.
When unit-Tests for the device will get implemented, the corect algoryth...
27.11.2023
-
21:25 Campo Wiki-Bearbeitung: Nodes (#4)
-
09:36 Biwak Feature #440 (Erledigt): RFM69CW: remove magick from packet structure
24.11.2023
-
14:38 Campo Feature #144: implement hwdata stterm command
- p/x (char [10])s
dump binary value foo (char[0x80])s
-
13:48 libcampo Feature #419 (Erledigt): make .campo optional
-
13:48 libcampo Feature #436 (Erledigt): Activate CVagus again
21.11.2023
-
13:57 libcampo Feature #419: make .campo optional
- Before this the candis debug build is:
candis.bin: 114076
now it is:
candis.bin: 114420
But has a lot of new ...
20.11.2023
-
20:39 CANBridge Wiki-Bearbeitung: Measurements (#3)
-
20:39 CANBridge Wiki-Bearbeitung: Measurements (#2)
-
20:38 CANBridge Wiki-Bearbeitung: Measurements (#1)
-
20:37 CANBridge Wiki-Bearbeitung: Wiki (#4)
-
19:23 MNThermo Wiki-Bearbeitung: Eval (#10)
-
17:51 mainSwitch Wiki-Bearbeitung: Eval (#48)
-
17:49 mainSwitch Wiki-Bearbeitung: Eval (#47)
-
17:27 mainSwitch Wiki-Bearbeitung: Eval (#46)
-
16:58 mainSwitch Wiki-Bearbeitung: Eval (#45)
-
15:43 Mito Feature #443 (Neu): implement validate mode
- When the button is pressed, the mode shall change.
validate:
* check the cable layout only on start
* check perm... -
15:32 Canbridge Feature #442 (Neu): Use listening mode
- Try to save current.
-
15:31 Canbridge Feature #441 (Neu): Measure current consumption in RX mode
- v0.1.0 does not use listen mode.
Will be interesting to campare with v0.2.0.
-
11:47 Biwak Feature #440 (Erledigt): RFM69CW: remove magick from packet structure
- The pre-magic is within the raw packet structure.
Just handle it like Post-Magic.
Reduce it to one byte to increase... -
11:21 CANBridge Fehler #430 (Erledigt): Transceiving is super slow and errornous
-
11:20 Canbridge Fehler #439 (Neu): Check RSSI instead of delaying
- Before sending an package, the RSSI should be checked instead of fixed delay.
Maybe sending multiple CAN-Messages be... -
11:07 Campo Feature #360 (Erledigt): Split further sensor library
- This is done: libscapus
17.11.2023
-
14:11 Hardware Wiki-Bearbeitung: Kabel (#9)
16.11.2023
-
18:04 libcampo Feature #436 (Erledigt): Activate CVagus again
- An template class that already handles default stuff like storing Configuration/HWInfo, handling NMT.
Just the funct... -
13:44 Campo Wiki-Bearbeitung: CAN-Bus (#5)
-
13:26 Campo Wiki-Bearbeitung: CAN-Bus (#4)
-
13:21 Campo Wiki-Bearbeitung: CAN-Bus (#3)
-
12:15 Campo Wiki-Bearbeitung: CAN-Bus (#2)
-
11:00 Campo Wiki-Bearbeitung: CAN-Bus (#1)
-
10:48 Campo Wiki-Bearbeitung: Wiki (#14)
15.11.2023
-
18:25 Cablemeter Wiki-Bearbeitung: Eval (#81)
-
18:16 Hardware Wiki-Bearbeitung: Needs (#43)
-
17:45 Hardware Wiki-Bearbeitung: Needs (#42)
-
15:22 mainSwitch Wiki-Bearbeitung: Eval (#44)
-
11:08 mainSwitch Wiki-Bearbeitung: Eval (#43)
-
11:06 mainSwitch Wiki-Bearbeitung: Eval (#42)
14.11.2023
-
16:22 Hardware Wiki-Bearbeitung: Needs (#41)
-
15:27 CANBuz Wiki-Bearbeitung: Eval (#37)
-
15:25 CANBuz Wiki-Bearbeitung: Eval (#36)
-
14:47 mainSwitch Fehler #434 (Abgewiesen): Power supply on CANBus is very poor
- Duplicate
-
11:58 mainSwitch Fehler #434 (Abgewiesen): Power supply on CANBus is very poor
- The traces are only 0.2mm
"Link":https://www.leiton.de/leiton-tools-spannungsabfall-leiterplatten.html -
12:01 mainSwitch Fehler #435 (Neu): Power supply on CANBus is very poor
- The traces are only 0.2mm
"Link":https://www.leiton.de/leiton-tools-spannungsabfall-leiterplatten.html
Sollte eig... -
10:40 mainSwitch Wiki-Bearbeitung: Eval (#41)
-
10:28 mainSwitch Wiki-Bearbeitung: Description (#8)
13.11.2023
-
15:29 Campo Wiki-Bearbeitung: TDT-Protocol_on_CAN (#99)
12.11.2023
-
10:46 Campo Wiki-Bearbeitung: HwData_Program (#3)
-
10:23 Campo Wiki-Bearbeitung: Nodes (#3)
-
10:16 Campo Wiki-Bearbeitung: Nodes (#2)
-
10:16 Campo Wiki-Bearbeitung: Nodes (#1)
-
10:15 Campo Wiki-Bearbeitung: Wiki (#13)
Auch abrufbar als: Atom